View all guides
b-box 3V+
Installation GuideBefore you begin
Required components for the installation
- The b-box 3V+
- The power supply cable
- The DSL splitter
- The DSL cable
- The Ethernet cable
The model of the devices/accessories may differ from the illustrations. If you have received this product as part of an exchange or following installation by a technician, you will already have the b-box or the accessories required for it to work. Do you need additional equipment for the installation (cables, etc.)? Please visit a Proximus point-of-sale outlet.
-
Skip steps 2 and 3 and connect the DSL cable to the blue DSL port on the back of the b-box 3V+.
Connect the filter
Disconnect any existing equipment or filters from your DSL connection socket and fit the supplied DSL splitter in its place.
-
In this case, check the position of the buttons on the back of the DSL splitter: they must be positioned fully upwards.
Connect the b-box to the filter
Use the DSL cable
and connect it to the blue DSL port on the back of the b-box.
-
-
Use a dedicated cable to connect the b-box between the DSL connection socket
and the telephone socket.
- Connect the telephone plug to the b-box using the DSL cable.
- Connect this to the blue DSL port at the back of the b-box.
This equipment (the cable used to connect the b-box, the telephone socket, the telephone plug) is not included in this box. It is either already part of your current setup or you will need to purchase it. The cable used to connect the b-box is a standard telephone cable (VVT or UTP – not recommended). You can buy one from a Proximus point-of-sale outlet or a shop specialising in electrical equipment. If you are using only a cable for connecting the b-box, make sure it is correctly connected to the DSL connection socket. -
Use a dedicated cable to connect the b-box between the DSL connection socket
and the telephone socket.
-
-
Turn it clockwise to detach it from its base.
- Screw the base to the wall.
- Then reattach the b-box to the base.
-
Turn it clockwise to detach it from its base.
Switch on the b-box
Connect the power supply cable to your b-box and to a power socket. The switch should be set to ‘I’ and the ‘POWER’ indicator light on the front will turn on.
Configuration and automatic updates for the b-box
Configuration time: 30 minutes maximum
Once the indicator lights below are turned on, you can proceed with setting up your TV Box, computer or other devices.
Various indicator lights will turn on depending on the services you have ordered.
-
- Is this your first time connecting to Pickx and/or the Internet? You’ll need to wait until the service is activated.
- Is this not your first time connecting to Pickx and/or the internet? Check that the DSL cable is properly connected to your b-box and the wall socket.
-
Solid blue light: the b-box is turned on.Solid blue: the b-box is synchronized.Flashing blue: synchronize (max. 3 minutes).Solid blue light: there is an Internet connection.Solid blue light: at least one LAN port is in use.Solid blue: the telephone service is configured correctly.Flashing blue: a call is in progress.Solid blue: at least one cordless handset (DECT) is connected.Flashing blue: a call is in progress.Flashing blue: indicates that WPS pairing is possible with another WPS-enabled Wi-Fi device (max. 2 minutes) or that a DECT handset can be paired with the b-box.Solid blue light: Wi-Fi is connected.
That’s it – your b-box is now configured!